This single double-spiral burnt orange beige floral crochet runner follows the supplied reference as one continuous oversized S shape rather than a chain of repeated medallions. Two opposing curled ends grow through alternating beige and burnt-orange bands, with narrow open ladder lanes separating the solid ridges. Each curl holds one layered orange flower over a circular fan of ribbed olive leaves.
Thank you for reading this post, don't forget to subscribe!Build two mirrored spiral lobes from counted centers, extend their bands into a shared curved waist, and join that waist into one continuous S. Repeat the same beige-orange stripe order on both halves. Add stepped outer points around each curl, then crochet two flowers and twelve ribbed leaves for the raised end rosettes.
Why You’ll Love This Project
The single sweeping shape looks architectural while using repeatable band rows. Warm neutrals suit autumn tables, open ladders keep the large piece light, and the two floral rosettes soften the geometric ends.
Materials
- About 720 yards warm-beige DK cotton yarn
- About 520 yards burnt-orange DK cotton yarn
- About 240 yards olive-green DK cotton yarn
- Small amount of golden-yellow DK cotton for flower centers
- 3.5 mm hook
- Yarn needle, scissors, stitch markers, tape measure, blocking mats, and rustproof pins
Gauge, Measurements, and Planning
Each curl begins with 10, 20, and 30 stitches. Complete one lobe through all concentric bands and block it to 19 inches before making the mirrored half. The joined waist should measure about 12 inches along its inner curve without puckering.
Make and wash a gauge swatch before beginning. Measure only after the swatch is completely dry. If the stitch width differs, change hook size rather than pulling the working yarn tighter. Keep a written count at the end of every section so the finished edges remain balanced and the assembly points line up.
Abbreviations and Special Stitches
- ch: chain
- sc: single crochet
- hdc: half double crochet
- dc: double crochet
- tr: treble crochet
- sl st: slip stitch
- sp: space
- st(s): stitch(es)
Special stitch guidance: Ladder band: dc in solid rib, ch 2, skip two stitches, dc in next rib. Stepped point: sc, hdc, dc, tr, ch 2, sl st in first chain, tr, dc, hdc, sc. Ribbed leaf: work graduated stitches around a foundation chain and surface-slip-stitch the vein.
Before You Begin
- Make exactly two mirrored spiral lobes and join them into one continuous S.
- Repeat the same beige-orange band order on both ends.
- Make exactly two flowers and twelve leaves.
- Block the S shape before attaching the floral rosettes.
Instructions
Crochet Two Mirrored Spiral Lobes
Use beige for the first center and mirror the tail direction on the second lobe.
- Round 1: With beige, make a magic ring and work 10 sc. Join. (10 sts)
- Round 2: Work 2 hdc in each stitch. Join. (20 sts)
- Round 3: Repeat [1 dc, 2 dc in next stitch] ten times. Join. (30 sts)
- Continue six increase rounds while alternating two beige rounds, two burnt-orange rounds, and one open ladder round. Keep the circle flat.
- Mark 40 stitches and extend them in turned rows to form a broad tapering tail. Curve the first tail clockwise and the second counterclockwise. Block two mirrored lobes.
Join the Curved Waist and Add Stepped Points
The two broad tails meet to form one unbroken S-shaped body.
- Overlap the tapered tails by 14 solid stitches and slip stitch through both layers in beige.
- Work one beige surface ridge and one burnt-orange surface ridge across the join so the stripe sequence flows through the waist.
- Around both outside curves, repeat short solid bands and open ladder bands, keeping the inside waist narrow.
- Finish each end with six evenly spaced stepped points and outline the complete runner in burnt-orange sc. Wet-block to 20 by 48 inches.
Make Two Flowers and Twelve Ribbed Leaves
Each spiral center receives one flower over six leaves.
- For each flower, make 10 yellow sc in a magic ring, increase to 20 sc, then mark five equal sectors.
- In each sector work one small orange inner petal and one larger burnt-orange outer petal. Make two flowers.
- For each leaf, ch 15 and mirror sl st, sc, hdc, 8 dc, hdc, sc, sl st around both sides. Surface-slip-stitch the center vein. Make twelve.
- Arrange six leaves in a circular fan at each spiral end and sew one flower over their bases.
Attach the Floral End Rosettes
Keep the rosettes centered inside the opposing curls.
- Pin one leaf rosette at each spiral center with leaf tips radiating evenly.
- Sew every leaf through its vein to solid beige stitches, then attach the flower through its center.
- Lift the petals and leaf tips during a final light steam-block.
- Tug-test the waist seam, both flowers, and all twelve leaves.
Assembly and Shaping
Join two mirrored lobes into one continuous broad S with a narrow waist. Keep the stripe order aligned across the seam and place one flower rosette at each curl center. This design has only two large opposing spirals; do not divide it into repeated small modules.
Lay every component on a flat surface before joining. Match the marked centers first, then divide each remaining edge into equal sections. Work through both layers with consistent tension and pause after each section to check that the fabric lies flat. This measured approach prevents twisting and keeps decorative details facing the intended direction.
Finishing
- Weave tails along matching solid bands.
- Reinforce the center waist from the back.
- Pin ladder lanes open and stepped points outward.
- Allow the runner to dry fully before attaching or reshaping flowers.
For a polished result, weave each tail through several same-color stitches, reverse direction once, and trim only after the fabric has been gently stretched. Block to the listed dimensions without flattening textured stitches. Inspect joins, borders, straps, and decorative pieces before the project is used or gifted.
Helpful Tips
- Label the two lobes clockwise and counterclockwise before joining.
- Use smooth cotton so the concentric ridges stay crisp.
- If the waist ripples, reduce stitches along its inner curve.
- Keep green confined to the leaf rosettes for clear contrast.
Good lighting and a contrasting stitch marker make counting much easier. If a section looks uneven, compare the current count with the previous checkpoint before continuing. Fixing one missed stitch early is faster than compensating later, and it preserves the measurements used by the assembly instructions.
Frequently Asked Questions
Can I make only one spiral lobe?
Yes. Finish it as a round centerpiece, but it will no longer form the reference’s double-spiral runner.
Why does the S shape bow?
Check that the tails overlap exactly fourteen solid stitches and that the inside waist did not receive extra ladder arches.
Can I change the colors?
Yes. Keep one light and one dark color so the concentric bands remain visible.
Conclusion
Two mirrored banded curls, a seamless central waist, stepped edges, and matching orange flower rosettes create the bold single double-spiral centerpiece shown in the supplied inspiration.
Printable Crochet Pattern Card
Project: Burnt Orange & Beige Floral Swirl Crochet Table Runner
Skill level: Advanced Hook: 3.5 mm Yarn: DK
Finished size: Approximately 20 by 48 inches after blocking
Card Materials
- About 720 yards warm-beige DK cotton yarn
- About 520 yards burnt-orange DK cotton yarn
- About 240 yards olive-green DK cotton yarn
- Small amount of golden-yellow DK cotton for flower centers
- 3.5 mm hook
- Yarn needle, scissors, stitch markers, tape measure, blocking mats, and rustproof pins
Card Instructions
- Crochet Two Mirrored Spiral Lobes: Make two mirrored 10-to-30-stitch spiral centers with matching beige, orange, and ladder bands.
- Join the Curved Waist and Add Stepped Points: Join fourteen waist stitches, continue the bands across the seam, shape the S, and add stepped outer points.
- Make Two Flowers and Twelve Ribbed Leaves: Make two five-petal orange flowers and two six-leaf olive rosettes for the spiral centers.
- Attach the Floral End Rosettes: Center and secure one orange flower-and-leaf rosette inside each end curl.
Finish: Check every count, weave in all ends, block to measurement, and inspect each join.
