This five-petal crochet flower hair clip with trailing leaves follows the supplied reference as a wearable adult hair accessory. One large raspberry-pink flower sits over a concealed clip, with five plump pointed petals arranged around a warm-orange round center. Four sage leaves frame the flower, while two narrow crochet cords hang below the hairstyle and finish with small leaf drops. The construction is lightweight enough for a low bun but structured enough to keep the petals visible.
Thank you for reading this post, don't forget to subscribe!Crochet the five petals separately from a counted center ring so each one has the same almond shape and raised ridge. Make four pointed leaves for the flower backing, two reinforced trailing cords, and two smaller terminal leaves. Assemble every crochet piece on a firm round backing, sew on a securely enclosed center button, then stitch the finished motif to a three-inch metal alligator clip.
Why You’ll Love This Project
The accessory uses small amounts of yarn but creates a bold handmade focal point. Separate petals are easy to shape, the leafy backing hides the clip hardware, and the two moving cords add the delicate trailing detail visible in the reference. It can be worn over a bun, clipped beside a braid, or attached to a fabric headband.
Materials
- About 55 yards raspberry-pink DK cotton yarn
- About 45 yards sage-green DK cotton yarn
- About 8 yards warm-orange DK cotton yarn
- 3.25 mm crochet hook
- One 3-inch metal alligator hair clip
- One 16 mm smooth wooden button or bead for the covered center
- Small oval of matching felt or a crocheted backing disc
- Yarn needle, sewing needle, strong matching thread, stitch markers, scissors, and fabric-safe craft glue (optional)
Gauge, Measurements, and Planning
Complete and lightly steam one large petal before making the remaining four. It should measure about 2 inches long and 1.25 inches at the widest point. Adjust the hook before continuing if the petal is more than a quarter inch different. The completed flower should be about 4.5 inches across without stretching.
Make and wash a gauge swatch before beginning. Measure only after the swatch is completely dry. If the stitch width differs, change hook size rather than pulling the working yarn tighter. Keep a written count at the end of every section so the finished edges remain balanced and the assembly points line up.
Abbreviations and Special Stitches
- ch: chain
- sc: single crochet
- hdc: half double crochet
- dc: double crochet
- tr: treble crochet
- sl st: slip stitch
- st(s): stitch(es)
Special stitch guidance: Petal ridge: work through the back loop on one side of the foundation chain and the unused front loop on the return side. Pointed tip: ch 2 and slip stitch in the first chain. Romanian-style cord: sc in the second chain, rotate the work, then repeatedly sc under the two horizontal side loops and rotate again.
Before You Begin
- The flower has exactly five large pink petals, not six.
- Keep the four large leaves behind the flower and the two small leaves at the ends of the cords.
- Use strong sewing thread to attach the metal clip; yarn alone can abrade against the hinge.
- If using a bead or button, enclose and sew it securely. This accessory is not suitable for children under three because small parts can be a choking hazard.
Instructions
Crochet the Flower Center and Five Pink Petals
Use a counted center to divide the flower into five equal sectors, then attach one shaped petal to each sector.
- Center Round 1: With raspberry pink, make a magic ring and work 10 sc into it. Join to the first sc and mark that stitch. (10 sts)
- Round 2: Ch 1, work 2 sc in each stitch around, and join. (20 sts)
- Place a marker after every fourth stitch to divide the center into five equal petal sectors.
- Each petal: Ch 13. Starting in the second chain, work sl st, sc, hdc, 5 dc, 2 tr, dc, hdc. Work the pointed tip in the final chain, rotate, and mirror the stitches along the unused loops on the opposite side of the foundation chain.
- Slip stitch the petal base across the next four marked center stitches. Repeat the petal instructions four more times, using one sector per petal. (5 petals)
- Surface-slip-stitch from each petal base toward its tip for about 1.25 inches to create the raised central ridge. Fasten off and shape the petals into a balanced five-point flower.
Make Four Backing Leaves
The large sage leaves frame the flower and help conceal the clip base.
- For each large leaf, ch 14. Starting in the second chain, work sl st, sc, hdc, 2 dc, 5 tr, 2 dc, hdc, sc; work a pointed tip in the final chain.
- Rotate the work and mirror the stitches along the opposite side of the foundation chain. Join at the leaf base.
- Surface-slip-stitch along the center chain to define a firm vein and leave a 12-inch sewing tail. Make four leaves.
- Lightly steam the leaves and curve two upward and two outward. Do not flatten the center veins.
Crochet Two Trailing Cords and Leaf Drops
The two cords should hang independently and end at slightly different lengths.
- With sage, ch 2 and sc in the second chain. Rotate the work, insert the hook under the two horizontal side loops, and make 1 sc. Continue rotating and working under the two side loops until the first cord measures 10 inches.
- Make a second reinforced cord in the same way until it measures 12 inches. Leave long tails at both ends.
- For each small terminal leaf, ch 9. Work sl st, sc, hdc, 3 dc, hdc, sc along one side, make a pointed tip, then mirror the stitches on the other side. Make two.
- Sew one small leaf to the end of each cord. Reinforce the join through the leaf vein three times, then weave in the terminal tails.
Cover the Center and Assemble the Hair Clip
Secure the hardware beneath the crochet so only the flower, leaves, and trailing cords remain visible when worn.
- With warm orange, make a magic ring and work 8 sc into it. Work 2 sc in every stitch for 16 sc, then one even round. Place the wooden center inside, decrease evenly to close, and sew the orange cover firmly to the middle of the pink flower.
- Arrange the four large leaves behind the petals at upper-left, upper-right, lower-left, and lower-right. Sew each leaf through its center vein and the solid flower center.
- Attach both trailing cords behind the lower petals, placing the 10-inch cord slightly left of the 12-inch cord. Stitch through the solid backing at least six times per cord.
- Sew a 2.5-inch crochet or felt oval over all tails. Position the metal clip horizontally across the oval and secure it with strong thread through the clip’s end holes and around the stationary upper bar. Add a small amount of fabric-safe glue only if desired, then allow it to cure fully before wearing.
Assembly and Shaping
Center the orange covered button over the five equal pink petal bases. Place four large sage leaves behind the flower so their tips remain visible between petals. Attach the two cords at the lower back, with their leaf drops at different heights. Cover the yarn tails with a firm oval backing and orient the alligator clip horizontally so the flower sits upright above a low bun.
Lay every component on a flat surface before joining. Match the marked centers first, then divide each remaining edge into equal sections. Work through both layers with consistent tension and pause after each section to check that the fabric lies flat. This measured approach prevents twisting and keeps decorative details facing the intended direction.
Finishing
- Weave petal and leaf tails into matching solid stitches before adding the backing.
- Steam lightly from several inches away while shaping the five petals and six leaves; do not press them flat.
- Tug-test the center, both cords, and the clip attachment before wearing.
- Let optional glue cure according to its label, then wipe the metal clip clean and check that the hinge opens freely.
For a polished result, weave each tail through several same-color stitches, reverse direction once, and trim only after the fabric has been gently stretched. Block to the listed dimensions without flattening textured stitches. Inspect joins, borders, straps, and decorative pieces before the project is used or gifted.
Helpful Tips
- Cotton yarn gives crisp petals; a cotton-acrylic blend produces a softer flower.
- Stitch the leaf veins to the backing but leave the outer leaf edges free for dimension.
- Use a clip with small end holes so strong thread can pass through the hardware.
- To prevent twisting, attach both cords before sewing the backing oval in place.
Good lighting and a contrasting stitch marker make counting much easier. If a section looks uneven, compare the current count with the previous checkpoint before continuing. Fixing one missed stitch early is faster than compensating later, and it preserves the measurements used by the assembly instructions.
Frequently Asked Questions
Can I make this without the trailing cords?
Yes. Omit both cords and their two small leaves, then center the four large backing leaves evenly around the flower.
Can I use a plain crochet center instead of a bead?
Yes. Stuff the orange cover lightly with yarn scraps and close it firmly before sewing it to the flower.
Why do my petals curl?
Check that the stitches are mirrored on both sides of each foundation chain and steam them gently over a petal-shaped template before assembly.
Conclusion
The finished crochet flower hair accessory combines five sculpted raspberry petals, a secure warm-orange center, four sage backing leaves, and two moving leaf-ended cords. Careful clip assembly keeps the hardware hidden while preserving the dimensional handmade look of the supplied inspiration.
Printable Crochet Pattern Card
Project: Crochet Beautiful Flower Hair Accessory
Skill level: Intermediate Hook: 3.25 mm Yarn: DK
Finished size: Flower approximately 4.5 inches across; full accessory approximately 6 inches wide by 15 inches long including cords
Card Materials
- About 55 yards raspberry-pink DK cotton yarn
- About 45 yards sage-green DK cotton yarn
- About 8 yards warm-orange DK cotton yarn
- 3.25 mm crochet hook
- One 3-inch metal alligator hair clip
- One 16 mm smooth wooden button or bead for the covered center
- Small oval of matching felt or a crocheted backing disc
- Yarn needle, sewing needle, strong matching thread, stitch markers, scissors, and fabric-safe craft glue (optional)
Card Instructions
- Crochet the Flower Center and Five Pink Petals: Build a 10-to-20-stitch center, mark five sectors, and attach five identical ridged raspberry petals.
- Make Four Backing Leaves: Crochet four symmetrical sage leaves with firm center veins and long sewing tails.
- Crochet Two Trailing Cords and Leaf Drops: Make reinforced 10- and 12-inch sage cords and finish each with one small pointed leaf.
- Cover the Center and Assemble the Hair Clip: Cover the orange center, layer four leaves and two cords, conceal all tails, and stitch the motif securely to a 3-inch clip.
Finish: Check every count, weave in all ends, block to measurement, and inspect each join.
